This page is engineered to provide refrigerated air to medium temperature spaces, the Wine Cabinet Cooler (CC) Units are Cabinet Cooler CC evaporators distribute air very quietly up to 10 feet to the right and left sides of the coil then return to the front.

These units are an excellent solution for wine closets and cabinets and are specifically designed to circulate refrigerated air in very small and medium narrow spaces.

These systems provide better BTU cooling per cubic inch of the required installation space providing a terrific temperature recovery time. This makes Wine Cabinet Coolers a superior choice for high-traffic areas. This is especially true for installations requiring a very low set point as with white wines.

Wine Cabinet & Closet Cooler Series Designed for Excellence

FEATURES

Aluminum cabinet with a subtle textured finish
fins are hard tempered for durability
Copper tubing completely seamless for a long trouble-free life
Cleaning and servicing louvered panels
Pre-Installed thermal expansion valve installed as standard
Compressor protection “pump down” solenoid valve as standard in case of leaks
Valves pre-installed in order to eliminate additional wiring to the thermostat
Highest cooling function with least required space for installation Both UL and NSF listed

Click here to download a PDF version of this page Download PDF Full Specifications Wine Cabinet Cooler Units

Bracket Mounting

Fan Coil Wiring

Condensing Unit Wiring

Field Wiring

L1115V Line Voltage

NNeutral

SVSolenoid Valve

FMFan Motor

TPTemperature Probe

Back of Controller Connections

10Temperature Probe

11Temperature Probe

4Neutral

5115V Line Voltage

2Jumper from 5

3Switch Leg to Fan Coil

C NOInternal normally open contact

CC Cooling System Typical Installation

Standard Line Sets should be 50′ or less. Extended runs may require larger line sizes and 3 oz of oil must be added for every 10′ feet over 35′.
Keep line sets as short as possible and insulate.
An excessive number of turns will cause refrigerant flow problems. This could cause early compressor failure. Suction line accumulators are recommended. Required if working lower than the normal 55-56 degree operating range from the wine cellar.
The drain line must always flow downhill to drain or pump.
The system is controlled by a pump-down control system. There is no control wiring between the thermostat and condensing unit.
The line connections at Fan Coil and Condensing Unit may not be the same as the required line sizes.

Questions? Click for help with Ceiling Refrigeration Lines Wine Cabinet Cooler  Series

Questions? Click for help with Walls Refrigeration Lines Wine Cabinet Cooler  Series